10-25-2025, 09:01 PM
Good afternoon, I have noticed that when I stop during a gate in dualchord, the gate remains activated and does not turn off until I press stop a second time. I find this annoying when working on a project and having to stop frequently, because sometimes, if you happen to stop during a gate signal, you have to press stop a second time.
Steps to reproduce:
Dualchord setup: TRIG 2 Destination DC-TR Output 2
Pattern screen: Gate programming
Start
Stop While the gate signal is activated.
Result:
The Dualchord gate remains active even though you pressed stop.
Best regards
Steps to reproduce:
Dualchord setup: TRIG 2 Destination DC-TR Output 2
Pattern screen: Gate programming
Start
Stop While the gate signal is activated.
Result:
The Dualchord gate remains active even though you pressed stop.
Best regards