XOR Userforum

Dualchord Local Trigger could not be triggered manually

Good day, when I set the trigger from Dualchord1 to Local Trigger, I cannot trigger it manually with OK when creating a new pattern to prelisten the line.

Steps to reproduce:
Track Assign:
Track2 NSA3: Dualchord

Dualchord Track Setup:
Note 1 Destination Out 1 Wave 1
Note 2 Destination Out 1 Wave 2
Note 3 Destination Out 1 Wave 3
Note 4 Destination Out 1 Wave 4
TRIG1 Destination Track Trigger
Note 5 Destination Out 2 Wave 5
Note 6 Destination Out 2 Wave 6
Note 7 Destination Out 2 Wave 7
Note 8 Destination Out 2 Wave 8
TRIG 2 Destination DC-TR Output 2

New pattern:
Dualchord1-1               Dualchord2-1
line 4  C-4  TRG30      C3 TRG30
line 8 B-3 TRG30        A-3 TRG30

Now when I press C-4 OK, DC-TR Output2 is triggered. I assume this is how it should be, as you want to trigger the entire line when you press it, but the local trigger is not triggered this way. So much for the first finding.

The second thing I noticed:
When I press B-3 with OK, only DC-TR Output2 is triggered again, but still with the previous note C-3. But when I press OK on line 8 C-4, I expect the entire line and its notes in this line to be updated, i.e. Dualchord2-1 A-3. However, in order for the note of Dualchord2-1 to be updated, you have to press OK on Dualchord2-1 note A-3. I find this a bit confusing, especially when creating different melodies on the two sides.

Thank you for your efforts

OK I see the issue.

Generally the functionality is (should be):
Prelistening in the first part will change all notes and the trigger of the first part, the same for the 2nd part. The note part seem to be fine but the trigger part is erratic when using something different than the regular dualchord triggers.

Will be fixed for the upcoming version.