Okay, I'm still pretty new at the Nerdseq; sorry if this is too basic. I haven't been able to figure out how to do a very simple thing: select a block of notes and move them up/down an octave or some other interval. I know there's gotta be a way to do this (without FX or Table please), but I can't seem to find anything in the manual!
Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
(07-29-2019, 08:34 PM)Barney Rubble Wrote: [ -> ]FX - basenote
Yeah, I was hoping to not have to use FX or Table. It's a little awkward that you can't just change a block of note names in the notes column so that you can actually, you know, SEE the new note names after you transpose. Guess if I want that, I just have to change the notes one by one; Ok for a few notes, but much more than that gets a little tedious. Thanks for the reply!
(07-29-2019, 08:51 PM)ianski Wrote: [ -> ]Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
Yay! That's what I'm looking for, thanks!
