XOR Userforum

Full Version: Release Candidate Firmware V1.20 RC5
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Quick Question:

Is there a way to select samples ( Trk 7/8) with MiDi input - there was some mention of CC or perhaps PG?
(09-05-2019, 05:21 PM)Barney Rubble Wrote: [ -> ]Quick Question:

Is there a way to select samples ( Trk 7/8) with MiDi input -  there was some mention of CC or perhaps PG?

Yes, program change should work.
Cheers mate - Program Change working like a dream Smile
Amazing update! Thanks! The ability to choose fonts really makes working with Nerdseq way easier for me!
Just press save ;-)
Scroll down the colours and all will be fine :-)
(09-07-2019, 04:16 PM)XORadmin Wrote: [ -> ]Just press save ;-)
Scroll down the colours and all will be fine :-)

Found it, stupid me! Thanks!
(08-28-2019, 04:42 PM)gr ib Wrote: [ -> ]
(08-26-2019, 11:37 AM)Hei XORadmin Wrote: [ -> ]
(08-06-2019, 07:51 PM)grib Wrote: [ -> ]Hi, I installed 1.20 RC2 and loaded a save-file from an older version (1.16 I think).

In the Automate screen there are some un-allowed values for some automation destination slots (see screenshot) and when I try to adjust these values pretty soon I will get an error as shown.  The Nerdseq locks up completely and doesn't respond to any keypresses.

If I clear theH slot with DELETE it goes back to -- and I can then adjust it within the legal range with no problems.

Hey Grib,

would you mind sending me the project file so i can test it and fix the issue?

Hey, yes!  Sorry I'm out of town a few days but I will send it to you as soon as I get back to nerd central.

Ok, sorry for the delay.  I'm attaching the file that causes this problem.  I had been playing with the automation LFOs before saving the file but I believe they were disabled when saved.
Hey Everyone,
I am not sure if this has been mentioned yet, but I was playing around with getting my Launchpad Pro working and I was stumped for a little bit thinking I did something wrong and it was not working.  I finally realized that by default, the tracks are all black colored.  Therefore do not show up on the launchpad unless you give them all a different color.  Could the track color default to gray to make launchpad use easier?

Thank you,
--Scott
(09-11-2019, 07:47 PM)gromler Wrote: [ -> ]Hey Everyone,
I am not sure if this has been mentioned yet, but I was playing around with getting my Launchpad Pro working and I was stumped for a little bit thinking I did something wrong and it was not working.  I finally realized that by default, the tracks are all black colored.  Therefore do not show up on the launchpad unless you give them all a different color.  Could the track color default to gray to make launchpad use easier?

Thank you,
--Scott

Yes i am aware of this but i think it makes only sense if you use the Launchpad with coloured patterns. Then it's full power can be used.
However, it makes definitely sense to use a slight grey colour for patterns without colour. I will try a bit what looks well and whats not in the way of the recent possible colours.
Awesome!!! Thank you so much!
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18