XOR Userforum

Current setup.

DIY case made of galvanised steel. 
The 2 modules with just jack's are just placeholders. planning to mod the erebus a bit
Also, planning an internal psu instead of the tiptop. and the midi expander is also going to be internal, with midiports on the back (the top as it is oriented in the pic).

(05-19-2020, 08:44 PM)zordid Wrote: [ -> ]Current setup.

DIY case made of galvanised steel. 
The 2 modules with just jack's are just placeholders. planning to mod the erebus a bit
Also, planning an internal psu instead of the tiptop. and the midi expander is also going to be internal, with midiports on the back (the top as it is oriented in the pic).

Nice work! Just for curiosity, what plans you have for modding erebus?

(05-20-2020, 04:38 PM)Johnny Wrote: [ -> ]

(05-19-2020, 08:44 PM)zordid Wrote: [ -> ]Current setup.

DIY case made of galvanised steel. 
The 2 modules with just jack's are just placeholders. planning to mod the erebus a bit
Also, planning an internal psu instead of the tiptop. and the midi expander is also going to be internal, with midiports on the back (the top as it is oriented in the pic).

Nice work! Just for curiosity, what plans you have for modding erebus?

Thank you.
Mods I'm thinking about / planning:
Input to the bbd delay and not through the filter/vca section first, 
Wet only separate output from the bbd delay. (if possible)
Switch for the envelope to vca / vcf / both.. 
high/low switch for the lfo (if possible. haven't looked that much at the circuits yet)
and new jacks with nuts (as it is now it feels like i'm bending the circuitboard inwards when putting in cables in the middle jacks.. (vca and so forth))

So... I upgraded my case, and swapped some modules... getting closer to a setup that takes me all the way...