+- XOR Userforum (https://xor-electronics.com/forum)
+-- Forum: Products (https://xor-electronics.com/forum/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://xor-electronics.com/forum/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://xor-electronics.com/forum/forumdisplay.php?fid=17)
+---- Thread: cv 16 won't change back to notes (/showthread.php?tid=1683)
cv 16 won't change back to notes - chriswest - 10-26-2023
On the cv 16 pattern screen I have come across the issue where if I surpass the note values + hexadecimal values by mistake and the tracker reads one of the internal envelopes + then I switch back to note values the tracker will cease to read any new note values.
it's like it's stuck or something.
Also there is a mystical "^" symbol next to the cv output destination indicator of the corresponding column. what does this mean?
In order to get rid of the issue I ended up restaring the project.
Anyone know what's going on in this situation?
thanks
RE: cv 16 won't change back to notes - XORadmin - 10-26-2023
That mysterical ^ means that you set this output to be an envelope. It's not stuck. It is once you set the CV output to be a LFO or Envelope it will act like this.
If you use the pure mode then a note will have no effect. In Add mode it will add to the envelope/LFO.
Possible solutions:
- Stop the Envelope from the Sequence
- Press SHIFT-Stop when the sequencer is stopped
- Use pure overrule from the Track settings of your CV16 track which will turn off the envelope once a note appears
- read how it works in the manual page 58
RE: cv 16 won't change back to notes - chriswest - 10-26-2023
I shall remain forever grateful!