+- XOR Userforum (https://xor-electronics.com/forum)
+-- Forum: Products (https://xor-electronics.com/forum/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://xor-electronics.com/forum/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://xor-electronics.com/forum/forumdisplay.php?fid=17)
+---- Thread: Octave/Interval transpose (/showthread.php?tid=454)
Octave/Interval transpose - atimbral - 07-29-2019
Okay, I'm still pretty new at the Nerdseq; sorry if this is too basic. I haven't been able to figure out how to do a very simple thing: select a block of notes and move them up/down an octave or some other interval. I know there's gotta be a way to do this (without FX or Table please), but I can't seem to find anything in the manual!
RE: Octave/Interval transpose - Barney Rubble - 07-29-2019
FX - basenote
RE: Octave/Interval transpose - ianski - 07-29-2019
Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.
RE: Octave/Interval transpose - atimbral - 07-29-2019
(07-29-2019, 08:34 PM)Barney Rubble Wrote: FX - basenoteYeah, I was hoping to not have to use FX or Table. It's a little awkward that you can't just change a block of note names in the notes column so that you can actually, you know, SEE the new note names after you transpose. Guess if I want that, I just have to change the notes one by one; Ok for a few notes, but much more than that gets a little tedious. Thanks for the reply!
(07-29-2019, 08:51 PM)ianski Wrote: Mark the notes then use the Nerd menu (shift > automate) to bring up the menu for transposing etc.Yay! That's what I'm looking for, thanks!
