XOR Userforum
Automator description on the pattern screen - Printable Version

+- XOR Userforum (https://xor-electronics.com/forum)
+-- Forum: Products (https://xor-electronics.com/forum/forumdisplay.php?fid=3)
+--- Forum: NerdSEQ (https://xor-electronics.com/forum/forumdisplay.php?fid=6)
+---- Forum: General Questions (https://xor-electronics.com/forum/forumdisplay.php?fid=17)
+---- Thread: Automator description on the pattern screen (/showthread.php?tid=657)



Automator description on the pattern screen - theotteryears - 03-03-2020

did I imagine this or did the pattern commands for the automators used to show up on the bottom of the pattern screen?

so I could tell what command was START/STOP/RESET etc. that doesn't seem to happen now..


RE: Automator description on the pattern screen - XORadmin - 03-03-2020

It works here. Select the good slot and be sure the LFO is also used in this slot.


RE: Automator description on the pattern screen - theotteryears - 03-03-2020

ok got it working... I must have done something wrong.

any chance we could have the reset command work when the LFO automator is in tick or pattern mode?

at the moment it only works in free or slow mode.


RE: Automator description on the pattern screen - XORadmin - 03-03-2020

(03-03-2020, 10:49 PM)theotteryears Wrote: ok got it working... I must have done something wrong.

any chance we could have the reset command work when the LFO automator is in tick or pattern mode?

at the moment it only works in free or slow mode.

No it doesn't work like that. If in tick or pattern it is coupled 1:1 to the mainclock. There is no reset here. One LFO iteration is always starting with step/tick 1 and ends with the last step/tick