02-19-2021, 08:18 AM
(02-19-2021, 08:15 AM)sak-rwsd Wrote:(02-18-2021, 11:07 PM)XORadmin Wrote: Hmm...it looks a bit like the RUN line gets interrupted somehow. (It should stay at 5 Volt when it's started and 0 Volt when it's stopped)
Not sure yet what causes the bars to glitch, maybe it is related in a way?
Can you check if there is a interruption of the RUN? ( NerdSEQ Reset input)
Hi Thomas, thanks. You inspired me to get VCV rack setup for the first time, so (for now) I could use the scope. I have CV tools sending clock and run to Pamela’s New Workout. I’ve multed this to NERDSEQ and in turn have sent a mult from NERDSEQ reset into my ES-9 (to follow on the scope). When I watch the scope, the Run voltage runs steady at around 4.15 per scope reading and all is fine - for awhile. When the NERDSEQ stops, there is indeed a brief dropout (looks like an inverted square wave or gate) to zero volts and then it starts again. Not sure what’s happening here! Let me look into it. Seems this wouldn’t be any fault of the NERDSEQ, but is upstream?
I just installed it and have it running for like 15 minutes and it is also still fine here. So the dropout causes your problems which causes to reset.
And as a follow up I think the graphical glitch happens caused by this. Like a too fast stop and start within a redraw point.
I see if I can reproduce that at least.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
