Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1.25 MIDI sync problem
#7
I am not really sure what it means (normal launch mode vs sync launch mode), but I do press SHIFT+START to start a row.
After reading page 18 in the 1.25 manual, I beleive I run in nomal launch mode. But again I may misunderstand what it means?

Just found it in setup, if its "Pattern Launch Type"? Its set to SYNC.

Also, I beleive I changed the "Reset FX on Seq Stop" to ON recently. And the problem is quite new to me, so it may have an impact?
Reply


Messages In This Thread
1.25 MIDI sync problem - by JX3D - 10-16-2021, 10:48 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-16-2021, 10:51 PM
RE: 1.25 MIDI sync problem - by JX3D - 10-16-2021, 11:00 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-17-2021, 10:31 AM
RE: 1.25 MIDI sync problem - by JX3D - 10-17-2021, 12:07 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-17-2021, 01:28 PM
RE: 1.25 MIDI sync problem - by JX3D - 10-17-2021, 01:46 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-17-2021, 03:16 PM
RE: 1.25 MIDI sync problem - by JX3D - 10-17-2021, 03:21 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-17-2021, 05:34 PM
RE: 1.25 MIDI sync problem - by JX3D - 10-17-2021, 06:16 PM
RE: 1.25 MIDI sync problem - by XORadmin - 10-18-2021, 12:58 PM
RE: 1.25 MIDI sync problem - by JX3D - 10-18-2021, 07:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)