0% would mean plays never and 100% means plays always. I see that issue and will see what I can do.
The other thing, there is no amplification higher than x1 (I will check what I can do here while keeping current patches to work correctly.
However, I think you could do a trick here if you allow to lose one CV or MOD output.
Create 1 slot with the CV IN and just read here the 0..5 volt with a 5 volt offset (so it creates a positive signal).
Create another slot with the same parameters.
Use for both a MOD or CV output as destination.
Then use another slot and use this MOD or CV as input. It should now be the input signal * 2. I didn't test this now but it might be a workaround that should work.
The other thing, there is no amplification higher than x1 (I will check what I can do here while keeping current patches to work correctly.
However, I think you could do a trick here if you allow to lose one CV or MOD output.
Create 1 slot with the CV IN and just read here the 0..5 volt with a 5 volt offset (so it creates a positive signal).
Create another slot with the same parameters.
Use for both a MOD or CV output as destination.
Then use another slot and use this MOD or CV as input. It should now be the input signal * 2. I didn't test this now but it might be a workaround that should work.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!