04-20-2022, 02:07 PM
I just received my new Brymen 869s multimeter and would like to check on the calibration of my CV16 expander.
How is the calibration supposed to work?
My current guess is this:
1) Assign the expander to a track
2) Assign a CV out to one of the 6 lanes (switch range to the right for 0V - 10V)
3) Set the 4-digit hex value on the track until the multimeter shows 0/1/2/3/4/5/6/7/8/9/10 volt and write down the respective hex values
4) repeat 2) and 3) for all 16 CV outs
5) In track setup update the 11 values for each of the 16 CV out according the values noted in 3) above.
Is that's how it is supposed to work?
Kind regards,
Michael
How is the calibration supposed to work?
My current guess is this:
1) Assign the expander to a track
2) Assign a CV out to one of the 6 lanes (switch range to the right for 0V - 10V)
3) Set the 4-digit hex value on the track until the multimeter shows 0/1/2/3/4/5/6/7/8/9/10 volt and write down the respective hex values
4) repeat 2) and 3) for all 16 CV outs
5) In track setup update the 11 values for each of the 16 CV out according the values noted in 3) above.
Is that's how it is supposed to work?
Kind regards,
Michael