Firmware V1.28 Test Version

[Renzki]

Howdy, here is a question about NRPN in relation to the new mapping tool on 1.28b

I have read this thread: https://xor-electronics.com/forum/showth...p?tid=1021 and many other papers available about NRPN (I never used it)

I'm trying to record an NRPN signal from the Arturia Minilab 3 that controls let's say, the analogue cutoff of the Erica Synths Black Dual VCF. I have entered the following on the mapping tool:

00_MCC_CH1_#6    > CV_PICH_CV1
01_MCC_CH1_#98  > CV_PICH_CV1
02_MCC_CH1_#99  > CV_PICH_CV1

On the keyboard, I have knob 1 configured to NRPN 1:1 (I tried all scales).

The ctrl message goes to the VCF, however there is a scale issue or something that keeps coarse scaling, I can hear it like it has only 128 divisions when moving the encoder, still far down from the 14bits.

Is there anything I'm doing wrong?

Thanks