08-01-2024, 06:05 AM
(This post was last modified: 08-01-2024, 06:09 AM by kriskeyman.)
Okay, I have the CVM-8 successfully set up for 0-10v inputs, connected to Nerdseq via I2C. One odd thing I'm noticing is that the output from my Levit8 with knob set to 0v level is showing Mapping Hex:002 when a cable is plugged from Levit8 output into the CVM-8 input, but then correctly showing Mapping Hex:000 when the same cable is instead plugged into CV In 1 on Nerdseq.
This is problematic when assigning CVM-8 input to track mute because the Hex never reaches :000, thus never unmuting. I applied an offset externally and the track muted/unmuted successfully, dropping to Hex:000.
But is it possible in Mapping to virtually 'offset' so that Hex:002 magically becomes Hex:000 instead? TIA!
This is problematic when assigning CVM-8 input to track mute because the Hex never reaches :000, thus never unmuting. I applied an offset externally and the track muted/unmuted successfully, dropping to Hex:000.
But is it possible in Mapping to virtually 'offset' so that Hex:002 magically becomes Hex:000 instead? TIA!