Clock Output

[digitalohm]

I don't see any bug here, neither a crash, so i moved this to General Questions.

The clock voltage is around 5 Volt (a bit less here) which is totally fine. If the Mordax can't read it, then the settings in the Mordax have to be changed if possible.

Check the Doepfer Eurorack Specs for Clock / Trigger voltages.
Beyond 3 Volt should be treated as 'High' and below 1 Volt should be treated as 'Low'. Between is undefined and can be different with every module.

http://www.doepfer.de/a100_man/a100t_e.htm

thanks.  i reported it to Mordax along with your link to the doepfer standard.

I see the part about "Within the A-100 usually any voltage beyond about +3V is treated as "high" (e.g. +5V, +8V, +10V, +12V will work) and will trigger an ADSR or any other module with a Gate or Clock input (e.g. trigger delay, sequencer, clock divider, clock sequencer). Any voltage below 1V is treated as "low". If the specification of a module differs from this voltage standard it is mentioned in the description of the module in question."

Hopefully Mordax will get this adjusted

Cheers