04-18-2025, 02:15 PM
hm, i am having a hard time to understand this. if the offset is zero half of the lfo is just useless. no matter the position of the cv offset switch. this behaviour doesn't mirror the display of the lfo position in the automate screen. adding an external -5 offset via another module doesn't really work, since the output still only gives half of the lfo.
from my logic the output should give negative voltage if the lfo is left of the middle marker and positive voltage if it is right. so, depending on where the switch is between -5...5V or between 0...10V
i simply can' wrap my head around the current behaviour and the description above. or is there a setting somewhere, that i missed?
from my logic the output should give negative voltage if the lfo is left of the middle marker and positive voltage if it is right. so, depending on where the switch is between -5...5V or between 0...10V
i simply can' wrap my head around the current behaviour and the description above. or is there a setting somewhere, that i missed?