Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
loop control in sequencer
#4
(10-19-2017, 06:08 PM)holo Wrote: I thought about going left from pattern 00 to select the Controls.. and then maybe up and down for counts.
You could build whatever formula ,have Counter ..

Edit:
but being able to make the most complicated sequences is a questionable target to achieve.

another more useful default pattern would be an empty one with configurable length "-0" for immediate jump acting as bridge across a gap, "-4" would be 4 bars of waiting before it goes on to the pattern below. i think i have seen default empty pattern "-" in one of the trackers i looked at.

and what about a jump control "↑2" could lead to one or more targets "↓2" to activate neighbor patterns for example while not having them filled with empty patterns for automatisation of  a sequence.
Reply


Messages In This Thread
loop control in sequencer - by holo - 10-19-2017, 02:50 PM
RE: loop control in sequencer - by XORadmin - 10-19-2017, 04:03 PM
RE: loop control in sequencer - by holo - 10-19-2017, 06:08 PM
RE: loop control in sequencer - by holo - 10-20-2017, 11:09 AM
RE: loop control in sequencer - by holo - 11-09-2017, 09:42 PM
RE: loop control in sequencer - by LostForWords - 04-06-2021, 06:25 PM
RE: loop control in sequencer - by XORadmin - 04-07-2021, 08:38 AM
RE: loop control in sequencer - by LostForWords - 04-07-2021, 07:07 PM
RE: loop control in sequencer - by mgd - 04-07-2021, 10:02 PM
RE: loop control in sequencer - by LostForWords - 04-07-2021, 10:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)