Tempo clocked LFO

[phantazm]

What is the proper way to create a tempo clocked LFO.  I've tried using Automations N*STEPS/STEPS but it is way too fast even at the lowest speed.  Also, I'm using the CV16 expander.

Thanks

[phantazm]

I figured out what I was doing wrong.  N*STEPS & STEPS does the trick.

[XORadmin]

I figured out what I was doing wrong.  N*STEPS & STEPS does the trick.

Yes N*Steps is N complete LFO waveforms per step.

And STEPS is that the complete LFO Waveform will last several STEPS.
The amount of both is defined by the speed field of the automator.

[XORadmin]

By the way: I don't suggest to route too many Automators to the CV16 as it generates much data. The best is to use the local CV outputs for automator stuff.

[phantazm]

Thanks for the info.

What is the proper way to reset the LFO at the start of a pattern/play?  I've tried adding the automator reset but this only seems to work at the end of the pattern and the next pattern loop plays as expected.

Thanks

[phantazm]

By the way: I don't suggest to route too many Automators to the CV16 as it generates much data. The best is to use the local CV outputs for automator stuff.

How do I use the local CV's for this? I assume the track type should be modular but I only see "Note" for the CV column.

Thanks

[XORadmin]

By the way: I don't suggest to route too many Automators to the CV16 as it generates much data. The best is to use the local CV outputs for automator stuff.

How do I use the local CV's for this?  I assume the track type should be modular but I only see "Note" for the CV column.

Thanks

I guess we are talking about different things. You can route/connect automators to the local CV/MOD outputs. It doesn't have anything to do with the Note column but it is for the CV output. That does work from every tracktype (except track 7 and 8 obviously).

[phantazm]

What I need is to apply the LFO to run on one of the local CV's instead of the CV16. I only mentioned the "Note" column in the pattern because it differs from how the CV16 works.

I have an LFO set up in Automator using CV/Track 5 is set to CV but its not working.

[XORadmin]

Then just use the CV as the destination. It is one of the destinations in the modulation matrix of the automator.

[phantazm]

It's working now. SMH I literally tried this 3 times. Thanks

---

Now, back to reset the LFO on play of a pattern? If I reset at the end of the pattern it works as expected but not at the beginning of play.