*SOLVED* Hang after performing a Fast Save

[induktor]

Hello,

I am experiencing an issue where my Nerdseq hangs after performing a “Fast Save”. The save screen displays “save project succeeded” and the device freezes at that point. A power cycle is necessary to restore operation. I am running firmware v1.18 C. Please advise.

Isaac

[XORadmin]

Hey, can you reproduce it with your file? You didn't remove the SD-card before you saved?
Can you maybe send me your project file so i can see whats going wrong?
I assume there is no issue with your sd-card.

[induktor]

Hello,

I tested this on two different project files with the same result. I did not remove the SD card prior to running the fast save routine. This only started to occur after the 1.18 update. I’m using the SD card that shipped with the module and it appears to be fine. I haven’t tried creating a new project and saving yet. I can also try a different SD card. I’ll report my test results.

Regards,

Isaac

[XORadmin]

Does it also happen when saving using 'save as'?
Can you send me the projectfile so i can test it myself. Here or via email if you don't want to share it.

[induktor]

I think that I found the cause. I am using a Sega game pad and the hang only occurs when I run a fast save using the controller. The issue does not occur when I save using the front panel controls. Something funky related to either the controller or the controller interface.

[XORadmin]

I think that I found the cause. I am using a Sega game pad and the hang only occurs when I run a fast save using the controller. The issue does not occur when I save using the front panel controls. Something funky related to either the controller or the controller interface.

Oh ok. Thank you. That's interresting. I wouldn't know why there can be a difference. But i'm gonna try it out tomorrow and of course fix it.

[induktor]

Now that I know the cause, I simply avoid using the controller when saving. I’ve been jamming out with the Nerdseq without problems since. Thank you Thomas!

[XORadmin]

Now that I know the cause, I simply avoid using the controller when saving. I’ve been jamming out with the Nerdseq without problems since. Thank you Thomas!

I can't reproduce that. Maybe you can provide me a project file anyway so i can check it.

[skybox]

Posting here to say it happened 1 time last night on a new project file. I'd be happy to provide if you like, however it hasn't happened again.

[XORadmin]

Posting here to say it happened 1 time last night on a new project file. I'd be happy to provide if you like, however it hasn't happened again.

Can you post a picture of the screen when it hangs, please? And is it always only with the gamepad?

Is there any more info you can provide? Like project name, maybe special characters, something with the samples, player was still playing, samples were still playing?

I really can't reproduce it and i saved for sure thousands of times without an issue.