Midi Input Question

[808man]

Hello,

Here is my scenario....

I am triggering Bitbox Sampler with Nerdseq via MIDI. 
-MIDI Data Input:ON
-MIDI Step Chnl.:OFF
-MIDI Channel 1: Track 1 Record
-MIDI Channel 2: Track 2 Record
-MIDI Channel 7: Track 7 Record

-Track Assign all set to MIDI Channel 1 (should I be able to assign to any channel?)

I am able to record channel 1 with no issues. When I switch my MIDI controller to channel 2, Nerdseq still sends MIDI out on Channel 1. Is there an option I am missing? When I check Track 2 Pattern Screen indicates "MIDI 1" (to the far right of screen). I am able to record on Track 7 with no issues. It is only Tracks 2-6 that I am having issues with.

Thank you,

Mike B

[XORadmin]

In the Input recording setup you decide the input Midi channel -> Track, so far so good.
In the Track (i assume a midi track aswell) you got to set the desired midi channel as well for output/sequencing channel. Standard for all tracks this is 1. Just change it to what you want. It routs the midi input channel then to the wanted output channel.

[808man]

In the Input recording setup you decide the input Midi channel -> Track, so far so good.
In the Track (i assume a midi track aswell) you got to set the desired midi channel as well for output/sequencing channel. Standard for all tracks this is 1. Just change it to what you want. It routs the midi input channel then to the wanted output channel.

Thank you! I did not realize there was another screen under Track Assign. Issue resolved!!!

[XORadmin]

Yes, the track setup.
Either under track assign. Or in the sequencer screen from the Nerd Menu.

Cheers!