11-14-2021, 10:24 PM
Hi,
I just need some clarification on the below part of the new firmware..
added launch mode function. beside the regular launch possibilities there is now an additional synchronizing to queuepoints/zero cross launchmode (Setup -> Pattern Launch Type)
unfortunately I had to sell my Nerdseq a little while ago to raise some funds, but I miss it and want to buy it again. this added feature was something I wanted last year and now I just want to make sure it works as I am hoping, before I spend some money on the sequencer again.
if I set my queue point to 56 (I like to work in 7/4 or 7/8) then with the new mode, all patterns will start on the next queue point and all begin from their STEP 1 at the same time?
I can't test this out myself, nor can I buy one and return it so I'm hoping someone can answer this for me.
Thanks in advance,
Chris
I just need some clarification on the below part of the new firmware..
added launch mode function. beside the regular launch possibilities there is now an additional synchronizing to queuepoints/zero cross launchmode (Setup -> Pattern Launch Type)
unfortunately I had to sell my Nerdseq a little while ago to raise some funds, but I miss it and want to buy it again. this added feature was something I wanted last year and now I just want to make sure it works as I am hoping, before I spend some money on the sequencer again.
if I set my queue point to 56 (I like to work in 7/4 or 7/8) then with the new mode, all patterns will start on the next queue point and all begin from their STEP 1 at the same time?
I can't test this out myself, nor can I buy one and return it so I'm hoping someone can answer this for me.
Thanks in advance,
Chris