Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DIN SYNC ISSUES
#3
(02-18-2021, 11:07 PM)XORadmin Wrote: Hmm...it looks a bit like the RUN line gets interrupted somehow. (It should stay at 5 Volt when it's started and 0 Volt when it's stopped)

Not sure yet what causes the bars to glitch, maybe it is related in a way?
Can you check if there is a interruption of the RUN? ( NerdSEQ Reset input)

Hi Thomas, thanks.  You inspired me to get VCV rack setup for the first time, so (for now) I could use the scope.  I have CV tools sending clock and run to Pamela’s New Workout.  I’ve multed this to NERDSEQ and in turn have sent a mult from NERDSEQ reset into my ES-9 (to follow on the scope).  When I watch the scope, the Run voltage runs steady at around 4.15 per scope reading and all is fine - for awhile.  When the NERDSEQ stops, there is indeed a brief dropout (looks like an inverted square wave or gate) to zero volts and then it starts again.  Not sure what’s happening here!  Let me look into it.  Seems this wouldn’t be any fault of the NERDSEQ, but is upstream?

UPDATE:
Increased the buffer size from 64 (was trying to deal with latency!) to 128 and so far it’s been fine for several minutes.  Works great this way.  Thanks!
Reply


Messages In This Thread
DIN SYNC ISSUES - by sak-rwsd - 02-18-2021, 10:54 PM
RE: DIN SYNC ISSUES - by XORadmin - 02-18-2021, 11:07 PM
RE: DIN SYNC ISSUES - by sak-rwsd - 02-19-2021, 08:15 AM
RE: DIN SYNC ISSUES - by XORadmin - 02-19-2021, 08:18 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)