Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Still Struggling with Quantizing HALP
(03-16-2021, 12:41 PM)Bleep bleep Wrote: Hello, you could set your table with an automator as source. 
Then use this automator in envelope mode and trigger it with the gates of the track you are using.

This gonna make the table to go one step every time you trigger a note.

Another way to do the same thing is to use a cv input instead as a source and just feed it with the trigger output of the track you use.

So you have choice to spend either a cv in or one envelope and one automator Smile

I could not get this to work at all. So frustrating. It didn't step every time a new note was gated. It would step every repetition of the pattern. So on 00 of my pattern it would advance one step in the table, not when the note gated the envelope... AND the table didn't quantize the pattern pitch to the allow notes in the table. 

Which brings me to something else....

The envelopes are terrible, they're noisy in my VCA. I can hear little "rattle sounds" regardless of attack and decay settings. I think it's in the decay stage. it's doing something stupid, don't know what. I don't have a scope, I just use my ears and it sounds like shit. I find it worthless.

I'm starting to develop the opinion that some of these features; envelopes, pitch quantize, ratcheting, clock dividing, are shit. The manual sucks too.

Messages In This Thread
Still Struggling with Quantizing HALP - by Karlo - 03-07-2021, 04:51 AM
RE: Still Struggling with Quantizing HALP - by Karlo - 03-17-2021, 02:05 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)