Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Still Struggling with Quantizing HALP
(03-18-2021, 05:20 PM)XORadmin Wrote: Let's relax and get back to the topic. I assume the quantization issue is solved now?
What about the envelope usage I asked for and my comments about ratcheting?

My envelope usage is basic. Type: ADSR, Source: Gate 1, Destination: Mod 3

This goes into the CV input of Intellijel Quac VCA. You can hear the aliasing best if you use a signal without a lot of high frequency content, like a sinewave bass or sawtooth wave with low pass filter rolling off all the highs. Use headphones.

I tried many settings to eliminate the aliasing. Slow attack, slow decay, fast decay, long release, high sustain, low amplitude, inverted... etc. I could still here the little blip.

I only speculate it's aliasing based on how it sounds. I also read a thread (I think it was on novation bass station 2 thread) where the consensus was the digital envelope was creating artifacts or noises in the output signal due to aliasing. 

Something to look into.

I haven't had the opportunity to try your pitch quantization configuration and I just found out there are table presets for ratcheting in 1.23? I'm hoping to have a little free time this evening to explore.


Messages In This Thread
Still Struggling with Quantizing HALP - by Karlo - 03-07-2021, 04:51 AM
RE: Still Struggling with Quantizing HALP - by Karlo - 03-18-2021, 07:14 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)