Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No table presets in my SD cards
#1
Hello, 
I see in the manual (P68) : Nerd Menu in the table screen (SHIFT+NERD) to get to the presets and 
 "The following presets are available",

But, i bought my Nerdseq in second Hand, and : Preset Empty...How can i have this preset?
Thanks you!!!!

Olivier
Reply
#2
The presets are not on the SD card.
I assume you just use an old firmware.
Update to the latest and it’ll be fine.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
Reply
#3
Hi, Thank you for your answer, but i'm in the new firmware (1.24)
I try this morning to use the new firmware again, updating Succeed, and preset always empty :-(

I 'm formating my sd card...
and try again
Reply
#4
The sd card is not needed for all of this.
If you run v1.24 then it is there.
Just shift+ nerd in the table. Go to the preset rule and select as always with shift left/right. Press OK to enable the preset.
I’m sure it’s fine!
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
Reply
#5
so, i'm just so sorry, yes, it's work :-(
I'm a newbee with Nerdseq, but already in love!!!!
What a module!!!!
thanks thanks thanks
Reply
#6
Don’t worry :-)
Just remember that editing always happens like this.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
Reply
#7
ok ;-)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)