Release Candidate Firmware V1.25 RC5

[XORadmin]

I'm back to give you more work, perhaps. Sorry again my dude

I was creating a project (it was created in V1.25 RC4) that was to be my template for new projects (with loaded samples etc), but when I loaded it later on after working on another project it suddenly had an extra +2500 something in groove.

At around steps 12-15ish they seem to be faaaaaaar more maxed out than going to W. I reloaded and it persists. Sometimes when I reload I can see the groove box for these steps as empty, and then it turns into 6. If it stays empty I can move it down to 6.

This is not an actual issue for me, I can just create a new project, but I thought you might want to have a look at this weird behavior.

When I go to my other projects or create new project there is no such issue. I might have created this issue, but with the one or two empty patterns I have on there I don't see how I could have accidentally added +2500 groove to three steps.

I checked your project and actually there was no difference in the save file related to the patterns between RC4 and RC5.
But checking the content of your project I think that you created these wrong grooves in another way. I guess by some kind of copy/paste which ended up in the wrong spot? Can you possibly remember the steps in this project? I am sure it has been saved with the issue already.