Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.25 RC5
#90
SHIFT + right is not working on the gamepad but works on the panel keys. I mentioned this before, it appears to still be broken. I know you said you cannot reproduce this. If I got into the gamepad mapping, when I press the right d-pad button, I am seeing the RIGHT arrow flash on the screen, so I know the NerdSeq is seeing my controller and my controller is working correctly. Also this is a brand new out-of-the-box licensed Sega controller, not a knock-off, and not used. Holding C + left or up or down all work as intended but C + right does not do anything in the pattern edit screen. Navigation via the right d-pad is fine.

Currently the only way I can increment a value in the editor is to use the shift+up to jump it up say an octave, then use shift+left to back it down to what I wanted. Not ideal workflow.

If I press C + right on the sequence screen, it moves to the next line instead of incrementing the pattern.

Should I try another gamepad?
Reply


Messages In This Thread
RE: Release Candidate Firmware V1.25 RC2 - by mgd - 07-14-2021, 02:08 PM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-02-2021, 11:58 AM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-08-2021, 01:24 PM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-09-2021, 05:52 AM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-09-2021, 11:50 AM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-18-2021, 03:50 PM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-20-2021, 12:37 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)