Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate Firmware V1.25 RC5
#95
(09-27-2021, 09:36 PM)Neurotypique Wrote: Hi all! I installed the RC5 and had some weird issues, all of them on the sequencer page.

When the sequencer is running and I try to launch an island or several using start on the corresponding pattern, or shift + start on the line, it doesn't play the one I launched but the one after in the island.
Also sometimes it'll just launch on step 48 even though all the patterns are 64 steps, shifting some of the sequenced off.

The last thing I encountered was that most of the time when launching a pattern, it'll just blink instead of having the solid line on the left of the pattern number. maybe this have something to to with the other issues or not.

Best,
Seb

Do you have this issue in Normal or Sync Launch mode?
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
Reply


Messages In This Thread
RE: Release Candidate Firmware V1.25 RC2 - by mgd - 07-14-2021, 02:08 PM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-02-2021, 11:58 AM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-08-2021, 01:24 PM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-09-2021, 05:52 AM
RE: Release Candidate Firmware V1.25 RC5 - by mgd - 09-09-2021, 11:50 AM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-18-2021, 03:50 PM
RE: Release Candidate Firmware V1.25 RC5 - by tuj - 09-20-2021, 12:37 PM
RE: Release Candidate Firmware V1.25 RC5 - by XORadmin - 09-28-2021, 04:44 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)