Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Allow Range in table should be used for arpeggios too
#1
Hi Nerds,

when creating an Arpeggio via ">>>" and "Allow Notes" the range is always confined to one octave. However when setting a lower bound via range the Range the Arpeggio is transposed up or down (depending on the value of the lower bound). It would be nice if Range could be used to control the spanning range of the Arpeggio.

E.g. when Range 00 > 18 is set then the Arpeggio would span 2 octaves. With Range -07 > 11 it still spans 2 Octave but would be shifted a Quint down. (you get the idea).

Kind regards,
Michael
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)