Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[NO BUG] Connected Octatrack stopping by itself
(11-02-2021, 05:58 PM)XORadmin Wrote: Yes, it would be great if you could provide the midi data.

However, I can also send you a special version where everything midi in an out is being recorded onto the SD card of the nerdseq. That might help, too.

But which version are you using? Can you provide your project so I can check if there might be any midi data except for the clock is being generated.
Also, did you contact the elektron support as well?

How do you know about A1 data?

Working on it...

That could be useful as well.

I'm on the latest release NS firmware. I'll see about getting the project file gzipped and uploaded. No word back from Elektron yet. I've been through many iterations of project files and firmware versions with the same behavior. There was a point I was sequencing my Disting EX over midi, but not recently.

The A1 bug was reported by several people on Elektronauts.

Messages In This Thread
RE: Connected Octatrack stopping by itself - by mntbighker - 11-02-2021, 07:57 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)