11-03-2021, 08:29 PM
(This post was last modified: 11-03-2021, 08:33 PM by mntbighker.)
(11-03-2021, 01:12 PM)XORadmin Wrote:(11-02-2021, 07:57 PM)mntbighker Wrote:(11-02-2021, 05:58 PM)XORadmin Wrote: Yes, it would be great if you could provide the midi data.
However, I can also send you a special version where everything midi in an out is being recorded onto the SD card of the nerdseq. That might help, too.
But which version are you using? Can you provide your project so I can check if there might be any midi data except for the clock is being generated.
Also, did you contact the elektron support as well?
How do you know about A1 data?
Working on it...
That could be useful as well.
I'm on the latest release NS firmware. I'll see about getting the project file gzipped and uploaded. No word back from Elektron yet. I've been through many iterations of project files and firmware versions with the same behavior. There was a point I was sequencing my Disting EX over midi, but not recently.
The A1 bug was reported by several people on Elektronauts.
Just to be sure. Reported by several people in combination with the NerdSEQ?
No, reported as an Octatrack firmware bug. Not related to Nerdseq. I have the midi capture running now, but so far no Octatrack stoppages.
(11-03-2021, 02:24 PM)mvdirty Wrote: I too am interested to see whatever midi data you are able to capture, as I have yet to see this behaviour with my NerdSEQ->OT setup (although right now I’ve enabled only very little in terms of MIDI in features of the latter.)
Out of curiosity, can you share your OT firmware version, AUDIO NOTE IN setting, track midi channel mappings, and the midi note mapping setting set for each track?
OT 1.40A
No channels in Nerdseq are assigned to the midi interface. The only thing I'm using midi for on Nerdseq is sending clock. Are you asking for Octatrack settings or Nerdseq settings?