Release Candidate Firmware V1.26 RC6

[XORadmin]

Ah, that's good to know!

I've been looking into those tables a bit and it seems straightforward and a bit more profound at the same time. Not sure if it's my lack of comprehension at play, or if the playback order / speed in the FX rows in the tables is not working like it should.

But when I apply a table to a simple 64 step sequence, with some values in the TP column, it works just fine. The Playback Order in the FX however only applies every now and then. Again I'm not sure if I just don't get it, it could be dependent of those Live Queue Point but I would expect them to kick in immediately when the table sequencer encounters them.

Just tried the same in the pattern itself, setting the values in the FX, and it seems to behave in the same way. With an instruction to play Regular Speed on step 1 and *2 on step 33, after one cycle it stays on the double speed. Perhaps it's not supposed to work the way I think but I thought I'd mention it ✌️

You can set the playback order to be activated directly or after the pattern. It should be activated in the first place directly. Didn’t test that with tables but I don’t know why it shouldn’t work there as well.