Release Candidate Firmware V1.26 RC6

[XORadmin]

I just received my new Brymen 869s multimeter and would like to check on the calibration of my CV16 expander.

How is the calibration supposed to work?
My current guess is this:
1) Assign the expander to a track
2) Assign a CV out to one of the 6 lanes (switch range to the right for 0V - 10V)
3) Set the 4-digit hex value on the track until the multimeter shows 0/1/2/3/4/5/6/7/8/9/10 volt and write down the respective hex values
4) repeat 2) and 3) for all 16 CV outs
5) In track setup update the 11 values for each of the 16 CV out according the values noted in 3) above.

Is that's how it is supposed to work?

Kind regards,
Michael

No. Switch indeed to the right. (Or calibrate with bipolar in mind) You assign a CV16 track. Then you go to the CV16 track setup.
Far below in the menu you find the calibration settings. Get them first.

Then choose the CV1 -> 0V value, change until you measure the closest to 0 Volt, do the same with 10 Volt.
Then press SHIFT+OK, the voltages 1 to 9 volt will be filled in interpolated. Then go to the 9 volt, change the value again until it is closest to 9 volt...down to 1 volt.
And the next CV output. The Expander is saving the values automatically once it is more than 10 seconds idle.