Firmware V1.28 Test Version

[XORadmin]

Howdy, here is a question about NRPN in relation to the new mapping tool on 1.28b

I have read this thread: https://xor-electronics.com/forum/showth...p?tid=1021 and many other papers available about NRPN (I never used it)

I'm trying to record an NRPN signal from the Arturia Minilab 3 that controls let's say, the analogue cutoff of the Erica Synths Black Dal VCF. I have entered the following on the mapping tool:

00_MCC_CH1_#6    > CV_PICH_CV1
01_MCC_CH1_#98  > CV_PICH_CV1
02_MCC_CH1_#99  > CV_PICH_CV1

On the keyboard, I have knob 1 configured to NRPN 1:1 (I tried all scales).

The ctrl message goes to the VCF, however there is a scale issue or something that keeps coarse scaling, I can hear it like it has only 128 divisions when moving the encoder, still far down from the 14bits.

Is there anything I'm doing wrong?

Thanks

NRPN is a subset of CC messages and what you actually do in your mappings is only using the plain cc values which would need to be calculated together to get your result. This is theoretically possible by making calculations on the #98 , #99 receptions to get the NRPN number and #6 and #38 to get the value, but it’s not an elegant way.
I was planning for NRPN support for the mappings but I am not sure if it will make it into this release.