Using nerdseq for amp envelope AND filter envelope

[babylonrisingofficial]

Hey everyone so I'm running four tracks on the nerdseq and using an envelope for the vca/amp on each voice through the internal ADSR in nerdseq, I was wondering what the best way to incorporate filter envelopes too, could I use the trigger out on those channels since they're not being used as I'm using the adsr internally or the mod out?

[mgd]

Hey everyone so I'm running four tracks on the nerdseq and using an envelope for the vca/amp on each voice through the internal ADSR in nerdseq, I was wondering what the best way to incorporate filter envelopes too, could I use the trigger out on those channels since they're not being used as I'm using the adsr internally or the mod out?

No. The Trigger outputs are either 0V or 5V.

You could either use the CV and MOD outputs of the so far unused tracks and set their values via FX commands or buy a CV16 NSA (or two...I have three ) which gives you tons of additional CV outputs.

Kind regards,
Michael