Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
cv 16 won't change back to notes
On the cv 16 pattern screen I have come across the issue where if I surpass the note values + hexadecimal values by mistake and the tracker reads one of the internal envelopes + then I switch back to note values the tracker will cease to read any new note values.
it's like it's stuck or something. 
Also there is a mystical "^" symbol next to the cv output destination indicator of the corresponding column. what does this mean? 
In order to get rid of the issue I ended up restaring the project. 

Anyone know what's going on in this situation?


That mysterical ^ means that you set this output to be an envelope. It's not stuck. It is once you set the CV output to be a LFO or Envelope it will act like this.
If you use the pure mode then a note will have no effect. In Add mode it will add to the envelope/LFO.

Possible solutions:
- Stop the Envelope from the Sequence
- Press SHIFT-Stop when the sequencer is stopped
- Use pure overrule from the Track settings of your CV16 track which will turn off the envelope once a note appears
- read how it works in the manual page 58
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile
I shall remain forever grateful!

Forum Jump:

Users browsing this thread: 1 Guest(s)