12-10-2023, 06:53 AM
I'm trying to clock a track (set to 'mapping' in clock mult settings) from a cv input.
I can see the values changing on the cv input from 000 to FFF and back.
I'm not sure how to proceed from here. The track tick needs to be triggered when the lo to hi threshold is crossed,
but only once, until the level goes down and then back up. Can't just look at the voltage level since that could cause multiple triggers.
Any suggestions?
I can see the values changing on the cv input from 000 to FFF and back.
I'm not sure how to proceed from here. The track tick needs to be triggered when the lo to hi threshold is crossed,
but only once, until the level goes down and then back up. Can't just look at the voltage level since that could cause multiple triggers.
Any suggestions?