Mapping Discussion

[zeitkunst]

Okay, thanks for the suggestions, I'll give them a try. It also looks like even with the CALC workaround (from earlier in the thread), the CV outputs remain in a single octave.

 
What exactly? I think the calc functions should work and I don’t know why the CV should be only within one octave. Maybe you can point me to what you mean.

Oh, what I meant was that when using the previously mentioned workaround (CALC PASS 00=1 > TRK TRK1 TICK) the CV output (for, say, pitch) only remains in one octave (C1 and C2 output the same pitch).

Still don't know what you mean   Where do you send the pitch and what do you send. And still the tick function doesn't work as expected until the maintenance release.

Just getting back to this as I was traveling for the holidays. So I'll try and give more details about my issue, which is still in there with the v2.00C release. And then I have another question about the CALC function and triggers

Here is my setup: external trigger coming in to CV in 1. I setup my mapping as follows:

* 00  CV  IN1  
* 01 CALC PASS 00=6 > TRK TRK1 TICK

In Track 1 I create a pattern, set the track clock to mapping. The trigger comes in (5V trigger), the steps in the pattern advance on track 1.

I have two issues now, one of which is the previous one that I will try and explain better!

* First, I set the note value in the pattern to be something like, C-4. I then put a C-5 on a different step in the pattern. No matter what octave I put for the note, the voltage remains between 0 and 1V. And, it seems as if the voltage output is not being output correctly between 0 and 1V, as changes between various half steps are not audible, and there is no voltage change on my multimeter. I haven't had a chance to map out the discrepancies exactly (for example, I don't hear or see any difference between C-4 and C#-4), but the main issue is: voltage remains between 0 and 1V, no matter the octave, and all of the voltage steps are not being outputted. I will try and map things out in the coming days.
* The second issue is that the voltage output seems to be delayed by some amount compared to my incoming trigger. Of course this is to be expected, given that a calculation is occurring. But the delay is enough to cause the voltage output (for my oscillator) to be offset from the incoming trigger enough to cause an audible slur to be heard. Is there a way to know the delay between the incoming trigger on, in my case, CV1, and the voltage output in the sequencer? Or, is it better to just use the trigger output from the sequencer itself to trigger downstream modules?

Thanks so much for your help on this!