Mapping Discussion

[XORadmin]

Posting with a follow up - I solved one problem but still have an issue.

My issue with notes being recorded from the CV inputs being off was caused by another module (mute switches) in the pitch CV signal chain dropping the voltage.  So that's solved: the calibration on both the NerdSeq and the metropolix is excellent.  Now if I pass pitch and gates using the input assign in the setup menu, everything tracks perfectly.  

When I try to do this with mapping though:

CV  IN 3 ---- > CV  PTCH  CV 4
CV  IN 4 ---- > TRIG GATE TR 4

The pitch doesn't track properly and ends up out of tune.  I'm guessing it's because the CV is being read 1000x per second or whatever the interval is and continuously updated as opposed to just being redirected straight to the outputs?  The original sequence is still there, just out of tune and sounding kind of alias-y or chorus-y.

Am I doing something wrong or is this just a limitation for now?  I've solved the problem eternally with passive mechanical switches but it would be even better to have it all managed internally (and be addressable in patterns for performance).

Most probably you got the live inputs also routed to the outputs? These will concurrent with each other one locking to the note and one passing the pitch continously.  With passing there is always sampling involved. And if the pitch is slightly different than the actual note then one will compensate it and one not.
Try to use only on of these. In the upcoming version you can turn on/off the live input through the mappings so only on part is needed.