New Firmware 1.16 Preview

[XORadmin]

thank you, thats helping

in the track status bar this doesnt show up btw, would be nice though.. instead of 'automation slot x'

Hmm? It does show up when you are on the values field. Just checked.

hmm.. funny .. i can see them now too but i also checked right before, twice, even ran through the numbers, and i can hardly believe that i missed it because i did look fot them at just the same spot where i can see them now..
a brain glitch maybe

Maybe you checked a slot that wasn't assigned to a LFO?
I will also take a good look on it. Still beta though...

tried again .. looks like pattern that were created before a lfo was present dont show that info even if you add lfos afterward. as soon as i added a pattern when a lfo was already in the list all pattern showed the info. 
if you decide not to fix it in the next 10years id be fine with that

In my version it always shows doesn't matter if the LFO was created before or afterwards....So probably i fixed this already ;-)
Getting close to the release with some surprises.