Is there a way to do an envelope, e.g. on the PWM? If I understood correctly, the LFO is a triangle shape and will run until it is stopped, otherwise that could be misused as a poor-mans envelope with linear shape.
It would be good to either have a few Envelopes for the shape to run through the waveform shape or on the PWM to shape sounds each time they get triggered. This would allow for sounds like typical roland type PWM basses (Envelope on the PWM) and Bassdrums etc. quite easily, even though a bassdrum could also be achieved by multiple notes and glide, to glide down. WAVE X velocity seems to be not in the list of modulation sources, e.g. for vibrato or if an envelope or one-shot LFO would available, this could do an in-module VCA, which may also be nice if driving a VCF a bit harder, so how much the VCF is driven could then be Envelope or LFO modulated easily.
A workaround could be to run the sequence at high resolution and edit “envelopes” into the sequence via FX values, though that would be a bit steppy and lots of editing.
It would be good to either have a few Envelopes for the shape to run through the waveform shape or on the PWM to shape sounds each time they get triggered. This would allow for sounds like typical roland type PWM basses (Envelope on the PWM) and Bassdrums etc. quite easily, even though a bassdrum could also be achieved by multiple notes and glide, to glide down. WAVE X velocity seems to be not in the list of modulation sources, e.g. for vibrato or if an envelope or one-shot LFO would available, this could do an in-module VCA, which may also be nice if driving a VCF a bit harder, so how much the VCF is driven could then be Envelope or LFO modulated easily.
A workaround could be to run the sequence at high resolution and edit “envelopes” into the sequence via FX values, though that would be a bit steppy and lots of editing.