Thread Rating:
  • 2 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate 1 Firmware V1.16 (RC6 UPDATE)
(07-26-2018, 06:38 AM)Gimber Wrote: Opening a project from v1.14 doesn't allow setting any automation (gives odd characters then eventually locks up). Is there a way to get an older project updated/imported so it can take advantage of the new features? I tried a save as but that didn't seem to help.

I updated to RC3 where the automation should be initialized well now when loading an old project.
Please try again to load your 1.14 project (not the new saved one). I couldn't try it out myself right now (no non working 1.14 project file), but i think it should be fixed.

Please let us know if it s fine now.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile

Messages In This Thread
RE: Release Candidate 1 Firmware V1.16 - by Odan - 07-24-2018, 09:11 PM
RE: Release Candidate 1 Firmware V1.16 (RC2 UPDATE) - by XORadmin - 07-26-2018, 09:11 AM
RE: Firmware Update Information - by shledge - 08-29-2018, 06:19 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)