Thread Rating:
  • 2 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate 1 Firmware V1.16 (RC6 UPDATE)
(07-26-2018, 02:32 PM)Gimber Wrote:
(07-26-2018, 09:11 AM)XORadmin Wrote:
(07-26-2018, 06:38 AM)Gimber Wrote: Opening a project from v1.14 doesn't allow setting any automation (gives odd characters then eventually locks up). Is there a way to get an older project updated/imported so it can take advantage of the new features? I tried a save as but that didn't seem to help.

I updated to RC3 where the automation should be initialized well now when loading an old project.
Please try again to load your 1.14 project (not the new saved one). I couldn't try it out myself right now (no non working 1.14 project file), but i think it should be fixed.

Please let us know if it s fine now.

Just gave RC3 a quick try and automators on the 1.14 project are now working well. Thanks!

Very good Big Grin
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile

Messages In This Thread
RE: Release Candidate 1 Firmware V1.16 - by Odan - 07-24-2018, 09:11 PM
RE: Release Candidate 1 Firmware V1.16 (RC2 UPDATE) - by XORadmin - 07-26-2018, 05:43 PM
RE: Firmware Update Information - by shledge - 08-29-2018, 06:19 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)