08-01-2018, 03:40 PM
(08-01-2018, 01:34 PM)XORadmin Wrote:(08-01-2018, 01:06 PM)XORadmin Wrote:(08-01-2018, 12:56 PM)shledge Wrote: It never fully drifts out, it's almost like there is a sync signal sent to it every few steps to "snap" it back.
I use it with 1, 4, 8 and 10 - all exhibit the same behaviour.
Can you send me the project please? So i can check the behaviour.
I just tested it myself and all seems fine. My guess is that the bitrate of the LFO is set to 4 or 2 maybe? Because then i get exactly the behaviour you describe. Speed 1 and bitrate to 16 and there should be no issue.
Bitrate set to 16 - the only difference was that I had them offset so they would be 0-5v.
I think the best way to show it is like this:
I I I I I I I I I
I I I I I I I I I
Top is the clock, bottom is the LFO - it's in "sync" but it slightly drifts every few steps.