Thread Rating:
  • 2 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Release Candidate 1 Firmware V1.16 (RC6 UPDATE)
(08-01-2018, 03:40 PM)shledge Wrote:
(08-01-2018, 01:34 PM)XORadmin Wrote:
(08-01-2018, 01:06 PM)XORadmin Wrote:
(08-01-2018, 12:56 PM)shledge Wrote: It never fully drifts out, it's almost like there is a sync signal sent to it every few steps to "snap" it back.

I use it with 1, 4, 8 and 10 - all exhibit the same behaviour.

Can you send me the project please? So i can check the behaviour.

I just tested it myself and all seems fine. My guess is that the bitrate of the LFO is set to 4 or 2 maybe? Because then i get exactly the behaviour you describe. Speed 1 and bitrate to 16 and there should be no issue.

Bitrate set to 16 - the only difference was that I had them offset so they would be 0-5v.

I think the best way to show it is like this:

I  I  I  I  I  I  I  I  I
I   I  I I   I  I I   I  I

Top is the clock, bottom is the LFO - it's in "sync" but it slightly drifts every few steps.
How do you measure it? 
And please add or send me the project file so i can check it.
PLEASE use the search function if something have been asked or discussed before.
Every (unnessesary) forum support means less time to develop! But of course, i am here to help!  Smile

Messages In This Thread
RE: Release Candidate 1 Firmware V1.16 - by Odan - 07-24-2018, 09:11 PM
RE: Release Candidate 1 Firmware V1.16 (RC4 UPDATE) - by XORadmin - 08-01-2018, 05:19 PM
RE: Firmware Update Information - by shledge - 08-29-2018, 06:19 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)