Clock Output

[XORadmin]

I noticed recently that Make Noise LXD and Optomix dont go as brighter when stroke with Nerdseq triggers compared with triggers from another modules. So it makes sense now knowing that the triggers have slightly lower voltage.

The voltages are in the correct range / not too low!! I think you trigger them too short...

Again: +3Volt and higher must be treated as 'High/ trigger'.

The trigger works, no doubt. but LPG are higly senitive of the voltage amount of a trigger. I even pass them thru an attenuator sometimes to get different tones.

Which input do you use for the LXD and the Optomix with NerdSEQ triggers?