Clock Output

[XORadmin]

I noticed recently that Make Noise LXD and Optomix dont go as brighter when stroke with Nerdseq triggers compared with triggers from another modules. So it makes sense now knowing that the triggers have slightly lower voltage.

The voltages are in the correct range / not too low!! I think you trigger them too short...

Again: +3Volt and higher must be treated as 'High/ trigger'.

The trigger works, no doubt. but LPG are higly senitive of the voltage amount of a trigger. I even pass them thru an attenuator sometimes to get different tones.

Which input do you use for the LXD and the Optomix with NerdSEQ triggers?

Ok, i just checked both Make Noise LXD and the Optomix manuals and all inputs of these are no regular trigger but more CV inputs.
As expample LXD expects 0-8Volt on the Control input, 8 - 10 Volt on the strike input etc..
Next example the Octomix: Strike expects a 8 Volt Gate. Signal inputs expect a range from 0 - 8 Volt.

So this is a non issue in this case as the trigger signals of the NerdSEQ are in fact the wrong signals to use as they are strictly 0 / 5 Volt.  These inputs of the makenoise stuff mentioned need CV inputs in other ranges to work correctly. Of course you can use either the MOD or CV outputs of the NerdSEQ for it.