Clock Output

[lohacker]

My clock out voltage is also around 2.5V and doesn't trigger some of my modules like Wogglebug 2014, G8 and Rainmaker (I also have Knight's Gallop and Four Bricks Rook but out of the case atm). With others works fine (Varigate/Voltage Block, Noise Engineering, Mutables)

Just to confirm. How do you all measure? With a running clock and the O'tool voltage measuring? I expect you know that it shows only an average voltage which is with a running clock betwenn 0 and 5 volt = 2.5 volt.

To measure the clock output you need to set the clock (in the calibration menu) and measure without anything connected.
Or you could measure using the scope and see if the pulses of the running clock are around 5 volt.

Wobblebug doesn't count as it doesn't have a clock input but 8 Volt CV inputs -> see it's specs.
G8 should be set to unipolar to work well i guess. Rainmaker should be fine.

Hello, I don't have a O'tool or a multimeter to precisely measure it. I've used an experimental method by sending the clock out to my Doepfer A152 CV in (it expects 0-5v), with the leds on the right showing how much big is the signal and 4 of them blinks with Nerdseq clock, instead with the Nerdseq trigger outs all 8 blinks (the same with other 5v triggers like Varigate 8+).
Regarding Wogglebug I usually clock it with other modules pretty easily in the 5v range, same with G8, it's just the weak Nerdseq clock out signal that produce this problem, in fact by slightly amplifying it clocks everything.