01-26-2019, 06:23 PM
(01-26-2019, 04:57 PM)XORadmin Wrote:(01-26-2019, 02:05 PM)roolib Wrote: Hello there !
It seems like my Nerdseq doesn't output any clock and reset anymore..I tried any clocking parameter, but it's still the same...Am I the only only one to experiment this kind of issue ?
(01-26-2019, 02:05 PM)roolib Wrote: Hello there !
It seems like my Nerdseq doesn't output any clock and reset anymore..I tried any clocking parameter, but it's still the same...Am I the only only one to experiment this kind of issue ?
More precisely, it doesn't work anymore, even in the V1.17...It tried to check the calibration, and on the row " Test clock out in 5v", and "test reset out in 5v", it says "ERR"...
I thought it was a V1.18 issue, but in fact i guess it's a more specific issue, maybe I am not in the good topic anymore...
For the clock-reset output and input tests you got to connect cables from the clock out +in and reset out+in. Else you always get the error. When now navigating through the test you should see the LEDs of both on depending on where you are and see the OK as the message. (If all is fine).
I am sure this is not related at all to the update and it is no bug either.
Thanks a lot for your reply !! Really sorry for that, the clock came back when I did again the calibration test... It came just after the updating, and it never happened before, so I was wrongly suspecting the candidate update...But everything is fine now !!
Once again, thank you a lot for your hard work, can't wait your next releases !!!