Release Candidate Firmware V1.18 (RC3 UPDATE)

[XORadmin]

RC2 Some observations -:
1 Loading update the screen said something like SD Card was empty ? blah blah - but process continued and update was successful
2 Loaded project from RC1 and project loaded at 1bpm should have been 120bpm

Otherwise seems to be ok at the mo

cheers
b

1 - When only powering on the NerdSEQ, it can be that the SD card needs more time to start up. Just hold the buttons until it works well after a retry. That has nothing to do with RC2

2 - Are you sure? There is no difference in that from RC1. So if you saved in RC1 or older versions with 120 bpm, it should load with RC2 on 120 bpm. Or did you have external sync?

1. Accepted it was possibly the SD card not seated properly - in any case RC2 works :-)
2. I just followed exact same start up sequence and the same RC1 project loads at 120bpm - I'm going to assume this SD card related nonsense.

Completely unrelated - Today I got a camcorder that has had intermittent failures for over a year working. I changed the SD Card so lets blame it on the SD Card - Happy Nerding peeps :-)


Cheers
b

Hmm...yes, i don't know why the BPM change happened. Only thing that comes in my mind is if you used some external clock. Once the NerdSEQ started up, there should be no issues with the SD card anymore. So keep us updated if it fails again.